I have an XB1 Mini I was planning to use for a mod on my 360 TE w/ bad pcb. Also itll add Xb1 support.
Anyways I load it up, try in SFV, its working well. Then I remembered reading if you hold Back/Start when plugging in it will load up in a different mode to add ps3/ps4(legacy) support.
I try that, still working in SFV. Kool. No, it stops. I check, its still getting power, Device manager still sees it however game controllers says otherwise.
![K7lzLMD.jpg]()
If I unplug and plug it in without holding anything it still causes this problem.
So I decide to try Update Drivers, Browse, Let me pick to locate an older one.
Sure enough if I roll it back to the 5/26/14 one it works fine. Also worth noting is it only shows 1 bar for Z, axis with these drivers as opposed to rotation as well on the others.
So I update to the newer 10/29/15 and sure enough it's doing it again. Shows up for about 4 seconds then dies. I try plugging in and out and managed to glitch it where both controllers are cached as shown.
![ECtXAqI.jpg]()
So now if I plug it in straight up, it will come up as the older driver version and work fine. If I plug in hold Back/Start then it detects as the newer and now it doesn't show up in the joy panel at all.
![zSRtgMM.jpg]()
Is this normal behavior for Windows 10? I'm not sure which driver it used prior to me plugging it in with Back/Start. I hate the idea of modding this out and if I held a button by mistake I can kill it until I fix up drivers. For now it is working however it's not on the latest driver so I don't know what updates/features I'll be missing.
Anyways I load it up, try in SFV, its working well. Then I remembered reading if you hold Back/Start when plugging in it will load up in a different mode to add ps3/ps4(legacy) support.
I try that, still working in SFV. Kool. No, it stops. I check, its still getting power, Device manager still sees it however game controllers says otherwise.
If I unplug and plug it in without holding anything it still causes this problem.
So I decide to try Update Drivers, Browse, Let me pick to locate an older one.
Sure enough if I roll it back to the 5/26/14 one it works fine. Also worth noting is it only shows 1 bar for Z, axis with these drivers as opposed to rotation as well on the others.
So I update to the newer 10/29/15 and sure enough it's doing it again. Shows up for about 4 seconds then dies. I try plugging in and out and managed to glitch it where both controllers are cached as shown.
So now if I plug it in straight up, it will come up as the older driver version and work fine. If I plug in hold Back/Start then it detects as the newer and now it doesn't show up in the joy panel at all.
Is this normal behavior for Windows 10? I'm not sure which driver it used prior to me plugging it in with Back/Start. I hate the idea of modding this out and if I held a button by mistake I can kill it until I fix up drivers. For now it is working however it's not on the latest driver so I don't know what updates/features I'll be missing.