Perhaps someone on this forum can help me out because I contacted Akishop Customs twice and have had no response and google and youtube have given me nothing.
I just wanted to say overall I am very happy with the board and for the most part it is working great for my needs which is PC, Raspberry Pi, XBox Original and XBox 360. However, I am having issues switch between LS/RS and DP in Xbox360 mode (haven't tested on any other platform).
According to the documentation
I should be able to press the following with firmware 1.22 to 1.66
LSB = Select + 2P + 3P
RSB = Select + 2K + 3K
But this does not work.
If I enter configuration mode by pressing SELECT + 1P, 2P and 3P and moving the joystick:
Left = LS, Up = DP, Right = RS.
Press START to exit Configuration Mode. Then it switches between LS/RS/DP however this is not easy to do while playing games so I figure this cannot be what is intended and it makes more sense to switch on the fly by pressing.
LSB = Select + 2P + 3P
RSB = Select + 2K + 3K
What am I missing or doing wrong? What is the purpose of configuration mode?
Just a suggestion but it would be even better for gameplay if it was only a 2-button press and hold to switch for example LSB = Select + 3K and RSB = Select + 4K once I release then it switches back to DP but remembers where LSB or RSB position. To forget the position, you could press Select again would reset position of LSB or RSB to default. Does that make sense to anyone else ?
Not sure what this one does, can anyone explain? And again, it seems to me that is just too many button presses to do in normal game play.
LSB + RSB = Select + 2P + 3P + 2K + 3K
I just wanted to say overall I am very happy with the board and for the most part it is working great for my needs which is PC, Raspberry Pi, XBox Original and XBox 360. However, I am having issues switch between LS/RS and DP in Xbox360 mode (haven't tested on any other platform).
According to the documentation
I should be able to press the following with firmware 1.22 to 1.66
LSB = Select + 2P + 3P
RSB = Select + 2K + 3K
But this does not work.
If I enter configuration mode by pressing SELECT + 1P, 2P and 3P and moving the joystick:
Left = LS, Up = DP, Right = RS.
Press START to exit Configuration Mode. Then it switches between LS/RS/DP however this is not easy to do while playing games so I figure this cannot be what is intended and it makes more sense to switch on the fly by pressing.
LSB = Select + 2P + 3P
RSB = Select + 2K + 3K
What am I missing or doing wrong? What is the purpose of configuration mode?
Just a suggestion but it would be even better for gameplay if it was only a 2-button press and hold to switch for example LSB = Select + 3K and RSB = Select + 4K once I release then it switches back to DP but remembers where LSB or RSB position. To forget the position, you could press Select again would reset position of LSB or RSB to default. Does that make sense to anyone else ?
Not sure what this one does, can anyone explain? And again, it seems to me that is just too many button presses to do in normal game play.
LSB + RSB = Select + 2P + 3P + 2K + 3K