Scenario 1: Hori V4/5/Kai PS4-PS3 toggle switch + dualmod with PDP MKX xbone/360. Where/how would I solder the PDP to the toggle on the V4 Kai? I don't care if it ends up PS4+x360 / PS3+xbone for whatever reason. I just want to use the built-in toggle from the Hori stick. Would this be any different on a VLX for that matter?
Scenario 2: I want to padhack/dual Hori FC4 + PDP MKX, same-ish thing, but swap out PCB from a Madcatz VS. Ideally, I would like to add the Gen toggle to the LS/RS.
Both setups will use Toodles' IMP v2. I'm assuming solder high+high/low+low together. Is there anything else I'd have to worry about (adding a transistor, etc)? And for the VS, would I go H+H -> LS ...for example?
Thanks!
Scenario 2: I want to padhack/dual Hori FC4 + PDP MKX, same-ish thing, but swap out PCB from a Madcatz VS. Ideally, I would like to add the Gen toggle to the LS/RS.
Both setups will use Toodles' IMP v2. I'm assuming solder high+high/low+low together. Is there anything else I'd have to worry about (adding a transistor, etc)? And for the VS, would I go H+H -> LS ...for example?
Thanks!