Hello!
I recently got around to assembling my very first stick! sanwa buttons and a hori hayabusa stick with a zero delay PCB.
I plan to use this stick primarily on my PC.
I connected everything up, connected it to my PC - it was recognized as a "generic usb joystick" which seemed alright, but then when I go to calibrate it and check if I wired everything the right way, I found that the joystick will only register two directional inputs and nothing in between them.
The "dot" will move directly from the center to the far right side of the test area, or to the very bottom center, but no actual free movement in between and it won't register any other directions.
I am very new to all of this and unsure if it's a problem with one of the parts, or something I might have done wrong with assembling it.
Hoping there is some solution, any help will be greatly appreciated.
Thank you.
I recently got around to assembling my very first stick! sanwa buttons and a hori hayabusa stick with a zero delay PCB.
I plan to use this stick primarily on my PC.
I connected everything up, connected it to my PC - it was recognized as a "generic usb joystick" which seemed alright, but then when I go to calibrate it and check if I wired everything the right way, I found that the joystick will only register two directional inputs and nothing in between them.
The "dot" will move directly from the center to the far right side of the test area, or to the very bottom center, but no actual free movement in between and it won't register any other directions.
I am very new to all of this and unsure if it's a problem with one of the parts, or something I might have done wrong with assembling it.
Hoping there is some solution, any help will be greatly appreciated.
Thank you.